Joining Steel Brake Pipes

Discussion in general land rover forum started by honolulujoe apr 5 2017.

Joining steel brake pipes.

There are three main methods of joining pipes together and attaching fittings to them. Some say it is not possible with steel only copper. Checking the condition of your car s brake pipes is a job that is all too easy to forget because the pipes are mostly hidden underneath the car. Smaller lines are usually joined by socket welding or screwing.

And he said no problem with joining the. Lines of 2 inch or larger are usually butt welded this being the most economic leak proof method. No one seems to do steel connectors foe 1 4 inch pipe only brass ones and i am sure that i have been told not to use brass fittings. However these pipes can deteriorate to the point where they start to leak causing a dangerous loss of brake fluid and eventually partial or even complete failure of the braking system.

I have a corroded steel brake pipe on the car it is only about 50mm at the rear end the rest of the line to the front of the car is sound. I have a bit of a prob i need to join two sections of 1 4 brake pipe. Some occasions call for replacing just a section of brake line rather than the entire length. Flaremaster joining brake pipes.

Brake lines suffer impact breakage and corrosion over time and need to be replaced. I have to change the brake pipes on my son s car as they are rusted over the back axle. My profile my preferences my.